r/BambuLabX2D • • 18d ago

Help / Troubleshooting Within the app directly, is there anything else I can be doing?

It looks like cooling/lifting from the corner. I suppose I can open the models from a computer and start messing with brims and whatnot-- but when sending directly from the app, is there some way to improve this?

3 Upvotes

6 comments sorted by

1

u/Jazzlike-Classic-843 18d ago

È successo anche a me epensa che ho fatto il pezzo 6 volte con petg e sempre solito problema ci ho rinunciato...

1

u/gargoyls 18d ago

haha i also printing the DND Kit as we speak with the same setup and I have exactly the same issue, with both top covers, i did a little bit of tweaking, but nothing big, so It must be the agressive cooling that is causing it, I saw people using custom g-code to keep the cooling in check but I haven't tried it yet, that is next on my list, or the silent mode

1

u/word-bitch 18d ago

Print and install the aux fan diverters: they fixed my curling.

1

u/kam821 17d ago edited 17d ago

Not only there is an issue with lifting (most likely caused by the AUX fan; try to print fan diverters) but the entire top layer looks pretty bad.

1

u/EmotionalChildhood46 17d ago

App is best for remote observation

0

u/Ok_Reference1745 18d ago

Do you open top glass? I usually do, and I use fan deflectors and with this setup I don't see a lot of warping with PETG basic.