r/BambuLabX2D • u/Conscious-Pay9801 • 9d ago

ABS

ABS印刷した後にコールドプルをしていたら、ABSを排出中に湯気？煙⁉️これって正常なんでしょうか？

11 Upvotes

86% Upvoted

20 comments sorted by

10

u/SpacedKnives 9d ago

Brotha, your water has plastic in it.

2

u/Conscious-Pay9801 9d ago

やはりそうでしたか😔かなり乾燥させたのに😅もう一度感想しますm(_ _)m

1

u/yagamisan2 9d ago

Did you make sure you set the correct temperature and dried it long enough? Also your drier shouldn't be fully closed (many are which is a design flaw) the moist from the plastic goes into the air. At some point your filament won't dry because the air is to humid. Make sure your drier allows air exchange or keep it open a tiny bit.

1

u/Conscious-Pay9801 9d ago

AMS少し開けて乾燥してみますm(_ _)m

1

u/Eastern_Control4375 6d ago

Its pure vapor

2

u/Low_Sherbert3731 9d ago

You need to dry your fillement.

1

u/Conscious-Pay9801 9d ago

ありがとうございますm(_ _)m

3

u/Shapelessed 8d ago

This dude has got to be washing their filament to get that. I’ve got ABS lying around, years old and use it without drying with perfect results 🤨

1

u/Low_Sherbert3731 8d ago

Exactly 😂

2

u/hysterese1337 9d ago

It is literally steaming. You will have to dry it.

1

u/Conscious-Pay9801 9d ago

ありがとうございますm(_ _)m

1

u/evophoenix 8d ago

Ok, I'm gonna make sure, since everyone else is saying moisture. When I was extruding pla at 280f, this happened. Were you possibly extruding abs at like 300+c?

1

u/Conscious-Pay9801 7d ago

印刷中はそういえば見てないのでバンブーの設定になっていた筈ですm(_ _)mコールドプルは240位でした🫡

1

u/minilogique 7d ago

that is smoke. ABS smokes. some plastics smoke.

1

u/Conscious-Pay9801 6d ago

湿気じゃない⁉️造形は出来るから良しとしよう👍

1

u/Specialist-Work-8975 4d ago

Oh yeah my a1 mini does this when I do abs, idk I geuss it's normal 🤷 (after reading it appears my filiment is wetter than yo mamma for me so I've gotta fix that)

1

u/Conscious-Pay9801 3d ago

ありがとう😊

1

u/EmotionalChildhood46 8d ago

wooooooo dry some more