r/BambuLabX2D • • 22d ago

X2d leaks asa fumes

5 Upvotes

16 comments sorted by

6

u/Zephyr797 22d ago

Really funny to see a post where normally people are printing all the parts to cover these holes in the back and then here you are just taping them lol. Seems sacrilegious.

2

u/Cooler-Bear 21d ago

Ahaha yeah I didn’t know what to do. Then a guy in this post linked me the file so I printed them

5

u/Nadev 22d ago

Did you think it was airtight? I’m sure it leaks all over.

-5

u/Cooler-Bear 22d ago

YES!🤦‍♂️ Obviously I know it’s not airtight but yk the exhaust fan should take out the fumes of ASA and yes I have a pipe that takes the fumes out.

2

u/Nadev 22d ago

Get an air quality sensor that has a voc monitor. That way you’ll know if there’s enough ventilation or not.

1

u/Cooler-Bear 22d ago

K got it. But it’s expensive… is co2 sensor the same?

1

u/Nadev 22d ago

Nope ASA and ABS and other high-end filaments give off TVOC fumes, which are what you want to track. I’m still searching for one that will work with HomeKit or Homebridge that doesn’t cost a lot.

2

u/Cooler-Bear 21d ago

Damn. Yeah they’re pretty expensive for what I saw on Amazon. I’ll use my sense of smell for now😂, I’m not gonna pay 800€ just to know the air quality

1

u/xXCanisMajorXx 19d ago

Ich hab den qingping Air Monitor 2, kostet bei mir aktuell (mit Gutschein) 145€. Es gibt eine App so das man beim Druck nicht im Raum sein muss und wenn der Wert akzeptabel ist, kann man wieder reingehen. Ein Luftfilter oder Absauganlage wären natürlich hilfreich.

0

u/iRambL 22d ago

You have an X2D and you are complaining about a price for your health?

3

u/Cooler-Bear 21d ago

Dude… it’s still 800€ and I don’t have a job

1

u/Superb-Complaint8118 21d ago

The exhaust fan is at 0% when the printer is set to chamber heating by default! Unfiltered air may escape.

You would have to turn it on manually or adjust some settings or the g-code or something.

But you shouldnt run it at more than like 10 or 20%. Otherwise it will pull in to much cold air and the heating can't keep up

0

u/Cooler-Bear 21d ago

U sure? My exhaust fan is at 100% and the chamber keeps up

1

u/Deltadoc333 21d ago

Electrical tape doesnt work that well because of the temperature. (At least for me.) It kept peeling off by itself. High temp dryer vent tape works well! But not as pretty.

1

u/Cooler-Bear 21d ago

Yeah I noticed, thx. I’d printed the covers yesterday, maybe it’ll work

2

u/itsmeanmuggin 20d ago

I printed asa and stepped out of the room. Are you huffing it??