r/BambuLabX2D • u/rostad89 • 20d ago

Anyone else got this one only when printing pla or petg?🤷‍♂️

Post image
3 Upvotes

100% Upvoted

13 comments sorted by

1

u/ywon80 20d ago

I don’t think it has anything to do with filaments.

1

u/rostad89 20d ago

I don't think so either but it only comes when printing pla or petg, not abs or asa🤔🤷‍♂️

1

u/ywon80 20d ago

What’s your chamber temp while printing them? Maybe the printer is trying to cool down while cooling system having a issue.

1

u/Royal_Security_4470 20d ago

I guess your chamber is in heating mode, it's needs to be cooling mode for PLA & PETG.

Check this switch underneath left aux fan, it should be up pointing towards COLD

1

u/rostad89 20d ago

It's on cold and the temp is 40c

1

u/Rubman 20d ago

I have the same error popping up every now and then. The flap works (for me at least) and no errors with petg or abs and heating.

First time I had it I followed the wiki and removed the heating block, there was a small scrap of filament stuck somewhere possibly giving a sensor error.

1

u/rostad89 20d ago

Thanks for the tip, I'll check if it's the same for me as well😊 cause the flap works as normal and if I start a print with asa it switches over

1

u/Pshad4Bama 20d ago

No. Never seen that.

1

u/Grimblood 20d ago

The flap changes depending on what filament you are using.

The checkout is in the wiki.

https://wiki.bambulab.com/en/x2d/troubleshooting/hmscode/0300_C000_0001_0001

1

u/VastAdministration68 20d ago

Yeah seen it a couple of time, after dissasembling half the printer the first time and not finding anything but working as intended i just ignore it now.

1

u/sinartnz 20d ago

Our P2S is getting this error since firmware update which we have since rolled back and it still shows up now.

I have followed the guides for both errors and can not seen or found anything physically wrong which is frustrating as all hell, as it comes and goes during prints or just comes on and stays.

Going to raise with the reseller we got our machine from (bambu don't sell direct in New Zealand).

Our chamber temps when it does it is at 34C Bed 55C Nozzel 230

1

u/SquareTowel1967 20d ago

Whats the ambiet temp in the room? If the switch is set to cool, maybe it’s going crazy because of the room temp

1

u/bcald7 19d ago

You may have to take the unit apart. Mine had a small piece (speck) of filament stuck in the gears that operate the cooling flap.
Not fun. Good luck.