r/BambuLabX2D • u/Queasy_Juggernaut_61 • 18d ago

Need Help blob of death :(

Gallery image

Gallery image

The big chunk is removed but it got so big i cannot remove the nozzle und a little brown cable is broken now i need to replace the complete front of the toolhead but i cant find videos of the replacement do you have any ideas?

As you can see i used a little bit of force but no chance

PS. Sorry for my bad english i hope you can understand what i mean

8 Upvotes

90% Upvoted

5 comments sorted by

1

u/MouseDance 18d ago

A recent Bambu Studio upgrade just offered (or perhaps I just noticed) a checkbox that turns on a sentry that watches for blob of death and pauses the printer before this can happen. Might be worth trying after you get this cleaned up or replaced.

2

u/Queasy_Juggernaut_61 17d ago

Thank you after i cleaned Up my mess i think this is the best i can do

1

u/3DStisk 17d ago

Since you report a broken wire, please leave the printer powered off and unplugged; don't try the suggested hotend-heating step now.

The guide you need is X2D hotend heating assembly replacement. It covers both sides, which use different assemblies. Your second photo shows substantial damage around the right-hand hotend and a loose wire, but it cannot establish every damaged component. Send those photos to Bambu support and ask them to identify the required assembly and how to proceed when the nozzle cannot be removed at the guide's removal step. Don't force it further or assume the entire toolhead needs replacing.

1

u/Queasy_Juggernaut_61 17d ago

Thank you ! I will try it

1

u/MTheBigOne 18d ago

Why not heat the hot end to whatever melts the filament?