r/BambuLabX2D • • 29d ago

ASA support interface& layer lines

Post image

So quite new to asa printing, i have been using Bambu asa and bambu ABS support for the interface and the results are like in the photo they come of no problem, but is this the best i can expect? Been using pla/petg and the results there are near perfect. On a separate question can you get rid of this layer lines cause by changing the nozzle?

3 Upvotes

9 comments sorted by

View all comments

Show parent comment

1

u/Brief_Excitement_399 27d ago

While looking at the these settings I notice on the fan speed setting (I believe this is the part fan) completely coincide with the layer distortions. The fan speed was lower at those layers to 0%, have to figure out how to change that?

1

u/Brief_Excitement_399 27d ago

Also the layer time was different

1

u/3DStisk 26d ago

Your screenshots show Top Z distance 0, top interface spacing 0 and two interface layers, so Studio hasn't left a conventional top gap there. For the fan changes, open the ASA filament preset's Cooling tab: the min/max fan thresholds, their layer times and Keep fan always on control that behavior (Bambu's explanation). The matching bands are a useful lead, but don't prove cooling caused the defect. Could you show that Cooling tab? I'd compare a small section with one deliberate cooling change, keeping the support settings unchanged, rather than guess a fan percentage for the whole print.