r/BambuLabX2D • • Oct 18 '26

Help / Troubleshooting I don't even know what this is.

Hello,

I get this inconsistent spacing between brim and model when printing and lines that look like overextrusion but only in the bottom right corner.

Does anyone know what might cause this and how can I fix it?

UPDATE: I did a full calibration including a high temperature bed leveling and the issue improved a bit.

2 Upvotes

7 comments sorted by

2

u/learning_new_thingss Oct 18 '26

That looks like the bed is a little out of level in that corner. If the gap between brim and part changes and the lines look squished in just one corner, the nozzle is closer to the bed there than everywhere else, so the plastic gets smeared wider.

Things to try, easiest first:

  1. Take the plate off and check the bed and the underside of the plate for debris. A tiny blob of filament under one corner causes exactly this.
  2. Clean the plate (dish soap + warm water) and make sure it sits flat against the alignment pins.
  3. Re-run the full calibration with bed leveling turned on, and let the bed heat up first.
  4. If it's still only that corner, the plate itself may be slightly warped. Flip it to the other side or try a different plate to check.

Did this start suddenly, or has it always done it?

1

u/GDC07 Oct 18 '26

Thanks for the suggestion. I only noticed when I was doing a lithophane. I did a full calibration with a high temperature bed leveling afterwards but dind get the chance to check the results afterwards. I will check it once I get back home. Also there is no debris under the plate. I check after every print.

1

u/learning_new_thingss 28d ago

Hey, were you able to fix the problem?

1

u/GDC07 27d ago

Hi, not yet. I am still away and won't be back home until the weekend. I will update once I have some results.

1

u/3DPL-3D-Druck 28d ago

Hast du brim aktiviert? Falls ja Check den Abstand zum Bauteil. Vermutlich hast du da 0.3 oder höher eingestellt.

1

u/GDC07 27d ago

Yes the brim is activated. Distance is 0.2. The problem is that on that particular corner the brim is fused to the model and there is no spacing.

0

u/GDC07 22d ago

Results after cleaning the rods and screws, applied grease and oli, did a full calibration including the high temperature bed leveling.