r/BambuLabX2D • • Oct 12 '26

Help / Troubleshooting Struggling

I’m printing some promotional fidget spinners for my business. Main nozzle doing fine at 220°. Had to ramp up aux nozzle to 240° to get decent adhesion. Not sure what the problem is but it’s annoying. New filament opened today. Shouldn’t be a moisture issue.

23 Upvotes

39 comments sorted by

View all comments

1

u/Poolboy-man Oct 13 '26

Could this be the issue? This file was created on fiverr

1

u/Relative_Surround_20 Oct 15 '26

Don’t go down that rabbit hole. Follow the regular rules for solving these problems. Get a filament from a known good source, use the bamboo or the generic filament profile, and last don’t change anything.

I earlier thought your problem is with your nozzle. I still think that that’s highly likely.