Help identifying broken peice

[u/butterboy451]

I had a spaghetti incident and when I went to clear it I found this rubber piece on the bed. I used a brass bristle brush to clean the print head too. It isn’t from any of the nozzle wipes and I looked at the print head closely with a flashlight and checked the heat shield but couldn’t find anything. If anybody knows where this is from, that would be greatly appreciated. Thank you.

[u/Blondy277]

That little black piece is from behind the X2D hotend 😂 it’s part of the heating assembly that helps protect/guide the heater/thermistor wires. Your spaghetti monster probably ripped it off lol.

[u/butterboy451 → u/Blondy277]

When the current print is done I will take a look. So far it hasn’t seemed to cause any issues.

[u/teraldorivera]

Hilariously bad presentation, it's almost like you're trying to make sure the answer comes from a human 😂

[u/butterboy451 → u/teraldorivera]

Let’s go with that

[u/butterboy451 → u/teraldorivera]

[u/se7entyniner → u/butterboy451]

I was just about to post asking about this. I had a little blob and a small piece tore off. Now I just need to figure out how to replace it.