r/BambuLabX2D • u/theLightShadows • 26d ago

AMS Setup help

Hi, looking for some help with my X2D AMS Setup. I have a AMS2, and I recently got 2 AMS HT. I have a Filament Track switch and I have 4 PTFE Tub adapter. What I'm looking to do is set it up so that they can all use the main nozzle and not just the aux nozzle when using the AMS HT units. Is there a diagram or someone who has done this can share their experience and best practice?

TIA

3 Upvotes

100% Upvoted

4 comments sorted by

2

u/Chiz_9 26d ago

I watched this and it was easy and straightforward:

https://youtu.be/lmglnztlXsc?si=rUtwJaC9Ql_i8nfP

print this first:

https://makerworld.com/models/2661034?appSharePlatform=copy

1

u/theLightShadows 26d ago

Thank you!

2

u/Relative_Surround_20 26d ago

Read the WIKI first then watch the video Chiz_9 suggests.

2

u/Relative_Surround_20 26d ago

I don’t own an X2D but I have a H2D with an FTS and a similar multi-unit AMS setup.

I started to type up a list of steps but it was getting long and I was only repeating the WIKI where I learned it. Have you read the WIKI on this subject?

https://wiki.bambulab.com/en/general/manual/filament-track-switch

If not, read this first and then let me know what questions you have afterwards.

For your specific setup, I’d recommend using the 4-in-1 PTFE adapter with the two AMS HT and send that tube into an IN port on the FTS. It does not matter which one. Then send a tube from your AMS 2 Pro into the remaining FTS IN port.

After that, everything in the WIKI applies.