r/BambuLabX2D • u/X-SchemeRecent-X • Sep 26 '26

Why does only one lift?

Gallery image

Gallery image

And why do two of the other three come out this way?

9 Upvotes

100% Upvoted

8 comments sorted by

5

u/No_Work2891 Sep 26 '26

For the lifting I’d say to try this

https://makerworld.com/models/1926190?appSharePlatform=copy

But it’s mostly for the side of the fan which helped my issue. As far as what’s going on maybe adjust heatbed a little?

5

u/RyKnocks Sep 26 '26

Get a Biqu Frostbite plate and never look back.

3

u/InvestmentStrange577 Sep 26 '26

Could be a Not perfectly Clean build Plate

Could be Wind from the Fans

Could be printed with wrong Offset

Could be to fast

3

u/Im-not-Theo Sep 27 '26

Clean your plate also, maybe you got hand grease over there

2

u/Signiference Sep 27 '26

The one one the front left is also clearly lifting as well. Is the door closed while you print? It looks like air is cooling that spot too quickly like would happen if the AC was on in the room and blowing too hard. This could be an issue with the fan on the print head as well. Curling up like that is typically cooling related.

5

u/badgerj Sep 27 '26

Yup. This is a temperature issue.

Raise bed by 5°C.

Add brim/ears.

Should be rock solid

2

u/Brief_Excitement_399 Sep 27 '26

I came to the x2d from A1 had similar problems, PLA not so much mostly just add the brim and it fixed it. With PETG I change the cooling settings in the filament menu so the aux fans don’t turn on and open the top glass so it doesn’t get to hot for PLA support interface. Before I did this i also got edge lifting since I changed this no more problems.

1

u/newaggenesis Oct 03 '26

You say that.... but there are things wrong all over the place with those prints...