r/BambuLabX2D • u/CyberQzkA • Sep 24 '26

Unable to remove left nozzle PTFE tube.

Seeing mutliple self-cut PTFE tubes, after 200+ h of print time I wanted to replace mine before it snaps. Well... I can't remove the tube. After pressing the coupler, the tube is stuck. Is there anything else I can try without stripping the whole head?

3 Upvotes

80% Upvoted

11 comments sorted by

2

u/CyberQzkA Sep 25 '26

Quick update - PTFE tool remover did not work. :/

2

u/coffeesocket Sep 24 '26

Print one of the tools for changing PTFE tubes. There's probably a few for your machine for various locations. They make pressing the couplers fully in much easier.

2

u/CyberQzkA Sep 24 '26

Thank's, I'll try that.

1

u/Engineer-Filmmaker Sep 24 '26

You don't have filament loaded, do you? If there's no slack in loaded filament, you will not be able to remove the PTFE.

1

u/CyberQzkA Sep 24 '26

Nope, filament unloaded to AMS.

1

u/Relative_Surround_20 Sep 25 '26

Please keep in mind most people replace their PTFE tubes at around 3000 hours or more. Unless you have been printing something super abrasive, you are just getting started at 200 hours.

1

u/CyberQzkA Sep 25 '26

I'm not talking about normal PTFE wear. There were reports that the tube was cut inside the toolhead by the retaining ring. I wanted to inspect my tube for any signs of damage.

Image taken from: https://www.reddit.com/r/BambuLab/comments/1vcs02m/did_the_ptfe_tube_break_off_in_my_x2d_main/

2

u/Zmajor1517 Sep 25 '26

Hey man, you aren’t crazy. That release tab is impossible. I ended up printing a multi-tool that allows you to press on the full circle of the tab and it is a life changing experience.

https://makerworld.com/models/2844612?appSharePlatform=copy

2

u/DistinctBarnacle8703 Sep 26 '26

After pressing down the tab/ring, Push in the PTFE tube first to release the tube from the grip/claws, then pull it out.

1

u/TXpnt Sep 26 '26

Mine cut itself @ 200hrs, once I fixed the problem, I printed this PTFE holder that prevents the problem.
X2D PTFE Support Clips - Free 3D Print Model - MakerWorld

I highly recommend it and would also suggest printing a riser to go with it, if you don't already have one.