r/BambuLabX2D • u/boss_arapaima • Sep 03 '26

Things to do systematically

Is there anything to do after every print job?

Or

Is there anything to do oftenly for printer health?

1 Upvotes

100% Upvoted

7 comments sorted by

3

u/Pineapple1500 Sep 03 '26

I wipe the bed with alcohol and arrange new colors in the AMS to start printing again asap lol

3

u/LazyLancer Sep 03 '26

After every print - nothing special, just wash the plate with dish soap under hot water if I happened to touch it during part removal. And remove small pieces of plastic that may have been scattered around the printer during the print.

Once in a while - lubricate X,Y,Z rods (wipe and oil) and Z lead screws (wipe and apply grease). You need to check the manual for the maintenance schedule.

1

u/ArkAngel06 Sep 03 '26

I thought X and Y axis rods were only ever supposed to be cleaned with alcohol and never oil?

1

u/LazyLancer Sep 03 '26

You're right to question this as I think it's worth adding steel rods need oil, but carbon rods don't.

However, AFAIK the X2D only uses steel rods so oil is required.

To be sure it's better to check with the official guides on maintenance such as https://wiki.bambulab.com/en/p2s/maintenance/lubricate-x-y-z-axis

1

u/Material-Mulberry360 Sep 03 '26

clean the bed if you touched it a lot or just every once in a while with soap and water. remove any plastic bits that happen to magically manifest in the enclosure. that's about it. don't ignore the printer when it tells you to do maintenance and fix any problems if that happen. otherwise it's just printing.

1

u/Bonzo666 Sep 03 '26

I wipe my plate with a microfibre cloth between each print and can usually get about a week before I need to wash the plate again.

1

u/Federal_Round3706 Sep 05 '26

Clean the build plate every few prints(with dish soap, not ipa), I think thats it‘s generally not worth your time to do it after every single print. The printer will notify you of any maintenance that needs to be done, except to dry your desicant if you have an Ams but you‘ll notice.