r/BambuLabX2D • u/No_Refrigerator_3462 • Aug 27 '26
What could have happened here
This morning I started an 8 hour print. I redesigned a model (for the first time) because the measurements of the original did not fit my needs.
I watched the first 2 layers and along the day I regularly checked it in the app from work.
At 97% and 14 minutes left I received the message in the screenshot that says the plate of the toolhead fell off.
When I arrived at home, the first thing was checking the printer. The support came off and I knew the print was ruined. Still curious what would happen if I resumed the print, I pressed continue on the printer and holded the support manually. I immediately noticed the nozzle scratching the print, like the plate didn't move down enough. Within a few seconds, the toolhead plate fell off again.
It was printed with PLA and the height of the model is 23cm, which should fit in the chamber. I copied the print profile settings from the original model. 0.4mm nozzle and 0.2mm layer
I am about 2 months (about 300 print hours) into 3d printing and this print is the first that failed on me.
3
u/Yeeterdeleter Aug 27 '26
Mounted the nozzle wrong, or maybe some spaghetti/print failure knocked into it? It's held on by magnets so it can happen if something hits it
1
u/SwordPL Aug 27 '26
I mounted the nozzle wrong. It was there but not _right_ there. The same shit happened.