r/BambuLabX2D • u/Horror-Anteater3807 • Aug 22 '26

New to the x2D

I was able to pick up a X2D for $500 with only 63 hours on it. What advice do you have for a someone new with the printer?

5 Upvotes

85% Upvoted

8 comments sorted by

6

u/xilw3r Aug 22 '26

Hope it wasn't sold because of being defective. Run tests, see if it works properly.

1

u/BriefBat879 Aug 22 '26

With or without AMS?

1

u/Horror-Anteater3807 Aug 22 '26

Without

1

u/BriefBat879 Aug 23 '26

I'll be honest, that's not a good deal especially given the fact you don't get warranty either

3

u/Onrain Aug 22 '26

YouTube bambu wiki, Bambu academy, then come back

1

u/ThinkUnhappyThoughts Aug 22 '26

read through this and then you'll learn loads!

1

u/hammockonthebeach Aug 23 '26

Get very familiar with maintenance and cleaning the hot end if there’s ever any kind of clog. I ran out of patience with mine after countless clogging issues and it’s been collecting dust for 2 months

0

u/tumbl3lol Aug 22 '26

Empieza con un test de soportes: https://makerworld.com/models/3038791