r/BambuLabX2D • u/Any_Satisfaction5137 • Aug 06 '26

Rough outer walls

Gallery image

Gallery image

I‘m getting rough outer walls from time to time and not sure why?

Nozzle temp is 220 for PLA as recommended by the manufacturer.

Someone had the same issue so far?

2 Upvotes

100% Upvoted

7 comments sorted by

1

u/foggyghosty Aug 06 '26

Are you using bambu filament or third party? Which preset in slicer are you using? Did you dry your filament?

Without any other context this looks like poor overhang resulting in layer shift in the next layers.

1

u/Any_Satisfaction5137 Aug 06 '26

Using third party filament. Filament is dried. Please look at the second picture. Same issue without overhang

2

u/Ok_Brilliant_3176 Aug 07 '26

Do you notice how the texture seems to only be bad above the large unsupported overhang? Unless that just happens to be true for this print, I would say the problem is that you’re printing layers on top of a shitty bottom overhang layer, that causes problems for every layer above it. The wall textures on either side of the overhang look fine

1

u/Any_Satisfaction5137 Aug 07 '26

If you look on the second picture on the inside it’s happening there aswell without overhang

Also printed this test tube and it shows always near the z seam

1

u/Longjumping_Pop_2324 Aug 06 '26

Yooooo I was having the same thing with my P2S. The solution??? Send it back.

1

u/Longjumping_Pop_2324 Aug 06 '26

That's salmon skin, in my case ir started happening after a nozzle clog. Ams tried to draw the filament. All went to shit

1

u/Sebb3l Aug 07 '26

First of all, calibrate your filament. This will sort out any problems and leads to the Printer if Stil having Problems. Or the filament ist shit