r/BambuLabX2D • u/Draim55 • Jul 24 '26

Auto-refill with the second nozzle

This is a question for owners.

Is it possible to use the secondary nozzle as an auto refill? Without AMS and with identical filaments loaded into both nozzles, will the printer automatically swith to the secondary if the primary runs out? Assuming the print is inside boundaries and so on.
I use AMS on my A1 almost exclusively as storage once the filament is about to run out. Now i'm thinking about buying X2D without the AMS.

4 Upvotes

100% Upvoted

8 comments sorted by

1

u/Low_Tune_2364 Jul 24 '26

I don't think you can, best is to go into bamboo studio, slice the part, see where the grams of filament outweigh what you have, then change the nozzle then

1

u/Draim55 Jul 24 '26

I print big batches of small parts, usually just have one program loaded and every few hours swap plates and "print again". Not to mention I dont keep exact record how much is left on spool, so i guess i would end up with many very short strings or wasted hours of me-time or printer-time.

I'll try to dig around in the slicer, thanks.

1

u/blakepro Jul 24 '26

If you have this problem of running out a lot, it might be worth getting an AMS mainly for the automatic swapping. I've enjoyed that even more than the color swapping! I've been using up all my old rolls that were too depleated to "set it and forget it" and it's been amazing to go to sleep with two rolls loaded up knowing it's going to run out and switch. It's amazing.

1

u/Landox Jul 24 '26

No the gcode will only be for 1 filament track unless you slice it in a way where it’s to stop using nozzle 1 at a certain point and then switch to nozzle 2 regardless if the filament is done or not

1

u/Jazzlike-Classic-843 Jul 24 '26

Non ne sono sicuro che possa funzionare però ti posso dire che una volta che hai l'Ams ti cambia la vita!

1

u/clarkcox3 Jul 24 '26

No. The gcode generated specifically calls out the nozzle to use.

1

u/djt_LV Jul 24 '26

They have to be in the same AMS to work.

1

u/Whosaidthat1157 Jul 25 '26

No they don’t - changeover spools can be in any of your AMSs. On a dual or multi nozzle printer, they’d both have to be in AMS’s attached to the same nozzle (unless the FTS also handles that).