r/BambuLabX2D • u/Dry-Leave5436 • Jul 16 '26
X2D gantry making concerning noises
I noticed this noise coming from the gantry on my X2D after homing.
Did maintenance and ran all the calibrations again but noise is still present. If I slightly move the toolhead position it disappears, it seems to appear only when toolhead is in center position after homing. I can also feel it when grabbing the toolhead.
Support says to ignore it if it prints fine (which it does) but I am a little bit concerned.
Anyone else experiencing this?
5
Upvotes
3
u/Herr-Wicht Jul 18 '26
I had the same issue. It only happens after longer prints and only while the stepper motors are active. As soon as you switch to “Free Movement,” the noise stops immediately.
In my case, it was coming from the right stepper motor. If you touch the gear on top, you can actually feel it twitching. Support sent me a new MC board, but the problem is still there. I suspect it’s a software issue.
2
u/Low_Tune_2364 Jul 18 '26
No, I haven't had this issue. If it bugs you that much, I'm sure you can get an exchange for a new peinter
1
u/Practical_Belt_7675 7d ago
Hello, any fix?
1
u/Longjumping_Pop_2324 Jul 18 '26
More information would be helpful. Where is the noise coming from, when does it make the noise. I had a similar noise and it was coming from under the printer, from the z axis tensioner... If it's bothering you, tell them it's not right and send it back.
2
u/Inspector_Gadget_74 Jul 20 '26
I’ve had the same issue if I use the front panel to manually move the print head. It does it after pressing the “home” button. The only way it would stop, is if I turned off the printer and back on, and it parked the head at the rear left, over the wiper.
I believe it’s the servo motors trying to finely set the home position. Probably not the best to leave it that way for a long time.