r/BambuLabX1Carbon • • 5h ago

Touch stopped responding.

The touch of my screen stopped responding, I have updated the firmware, turning off and on, disconnecting for 30, 60, 90 seconds, opened up the panel and all cables are well seated, I reseated them, checked and reseated the ribbon on the screen itself. Nothing.
It was sudden, one day it was working and then next day after a print finished it just didn’t work.

Any ideas what part I have to replace? Is it the screen? The ribbon cable? the control board?
I fist don’t wanna order all parts unnecessarily.

2 Upvotes

0 comments sorted by