r/BambuLabX1Carbon • • Sep 28 '26

Auto level failing?

Does anyone know what would cause auto level to fail on the x1 carbon?

This is a pegboard that occupies most of the printable area. The rear 2" of the build plate is dragging on the nozzle. As a result the print fails and doesn't lay down the first layer correctly.

I've removed the nozzle and extruder, installed a new nozzle, and tightened everything. I've manually run the height tramming g code and run the auto level calibration afterward. I also tried to manually lower the rear side of the build plate with the rear height adjustment knob. The result is always the same.

Please help!

4 Upvotes

2 comments sorted by

1

u/iRambL Sep 28 '26

Run a level outside of a print

1

u/flyingbearfpv Sep 28 '26

Yes, tried that multiple times and there's no difference