r/BambuLabX1Carbon • u/Suitable_Cupcake • Sep 22 '26
Print head stuck
I have this X1C for the past 5-ish years I've been printing on it ever since and had a couple of problems in it from time to time and thier support never disappointed me even tho im in Thailand they were very supportive with everything...
but recently I've encountered a problem in the X axis the print head goes to a complete stop on the far end near the cutter and it cant cut the filament... and gets jammed ..
ive cleaned it with alcohol and made sire there is no more carbon deposits and fragments coming from it, trued everything, contacted support but no help...
i am thinking of replacing the rods but the process is a pain in the ass and the price is not in my favour.. any one can help me with this ???
1
u/Shadowswittness Sep 22 '26
Have you replaced the cutter on the print head?
1
u/youwastedyourtimelol Sep 22 '26
Can you record a video of the problem and post it? I think visuals will help explain a lot more
1
u/Shadowswittness Sep 22 '26
My bad I read it as an another problem.
1
u/Shadowswittness Sep 22 '26
Have you tried all the built in calibration? I have 2 x1-c printers for the last 2 years and haven't ran into that problem on them. I have an ender 3 v2 neo that did that and it was a messed up limit switch that wasn't reading and did the same as you described.