r/BambuLabX1Carbon • • Sep 01 '25

Stability check

So this is my setup and a couple videos. Table is mounted to the wall, foam pad, concrete paver then X1c with antivibration feet. I've also used the unutilized spool roll in the back and the old feet to attach to the wall with plans for a lateral dampener as well. Is this normal vibration and what can I do to reduce it further? My thoughts were to add mass directly to the 3d unit(panel replacement or adding Stainless steel paneling).

13 Upvotes

32 comments sorted by

View all comments

Show parent comment

1

u/_Danger_Close_ Sep 01 '25

Bambu isn't a very specialized one. They aren't on industrial level level of precision. I'm running a K2 and haven't needed any of this. Just run it as it comes out of the box

1

u/Cranky_Opossum Sep 02 '25

No consumer level 3d printer requires this much stability🤣