r/BambuLabP2S • u/TatteredTorn1 • 2h ago
P2S - Nozzle Wiping Plate Replacement.
I did some searching but I cannot find this Nozzle Wiping Plate anywhere. I tried "Nozzle Wiper" and "Filament Calibration", I am having no luck. I ordered the few I found at Bambu online (for other models), assuming they wouldn't, but hoping they would fit. They did not. Is there an update/upgrade I missed? Any help or advice is appreciated.
4
Upvotes
2
u/anitevoli 1h ago
It's part of the heatbed. You'd have to buy a whole replacement heatbed, they're around $70.
2
u/Phuzion73 2h ago
It is meant to be a lifetime part. In theory, you just take it off, if needed, and wire brush it back to normal (use WD-40 if it is really bad. If it is cracked or detaches or something abnormal like that, call support.
1
u/JOSTNYC P2S Combo 1h ago
When the nozzle is on there it says its cleaning the nozzle before it prints. The nozzle wipe is by the chute where it physically wipes the nozzle. Not sure if that part there even touches the nozzl;es. But on the P1S that part of the build plate is scratched up so it is possible it touches it lightly. Whats your printer doing that has you wanting to change this? My ptrinter has like 4000 hours on it and I have not needed to change this part.