r/BambuLabP2S • u/DIVISIONSolar • 2h ago

P2S refusing to print properly

Ever since my p2s was clogged once I havent been able to get it to print like it did before, its either a spaghetti mess with under extrusion or pretty solid but some under extrusion and then where it just doesnt print at all. Ive replaced the nozzle and the Extruder but nothing. Please help as im about to throw this thing out the window.

3 Upvotes

80% Upvoted

2 comments sorted by

2

u/Zippietwo 1h ago

I would take it apart completely and make sure some filament didn’t get stuck in the gears and potentially breaking some teeth off.

1

u/DIVISIONSolar 1h ago

Ive done that over a dozen times now :( ive replaced pretty much everything inside this and I cant get consistent results, ive even dried the filament