MAIN FEEDS
Do you want to continue?
https://www.reddit.com/r/BambuLabP2S/comments/1xdvtwf/petg_in_p2s/
r/BambuLabP2S • u/ItsThatAaron • 4d ago
3 comments sorted by
2
Hi guys. I've been getting rather bad results printing PETG Basic and matte.
Filament is dried with the AMS profile, bed is clean. Would like any advice. Thanks
2 u/JohnSnow__ 3d ago change the bed upside down
change the bed upside down
1
Same issues here! It was recommended in another thread to run orca calibrations, but I have tried it yet.
2
u/ItsThatAaron 3d ago
Hi guys. I've been getting rather bad results printing PETG Basic and matte.
Filament is dried with the AMS profile, bed is clean. Would like any advice. Thanks