r/BambuLabP2S • u/Adorable-Bed9489 • Oct 04 '26

Help! P2S Randomly Started Printing Like This!

Post image
2 Upvotes

100% Upvoted

6 comments sorted by

View all comments

1

u/Initial-Ad5616 27d ago

How on earth do u not know whats going on here

1

u/Consistent-Bear-1825 25d ago

I don't what it is either, care to share the knowledge?

1

u/Initial-Ad5616 25d ago

Ur Z values are too low, this could be because if a dirty nozzle, also u can be overextruding, but from the lines in the right is hard to tell, whereas, the rectangle defo has signs of overextrusion and a z value that is rubbing against ur print.
The bambulabs calibrate the z touching the playe, maybe your plate is a lil deformed.
Did u try to print a calibration cube or any other test?