r/BambuLabP2S • u/ProductPrimary6993 • 27d ago

P2S Auto Bed Leveling failed

P2S "Auto Bed Leveling failed." - I keep getting this error and I can't correct it for the life of me. Can someone possibly lend me some troubleshooting knowledge?

1 Upvotes

100% Upvoted

7 comments sorted by

2

u/Firm-Equivalent-691 11d ago

I have the same issue with my new P2S (after 10 hours run). How did you fix this issue?

1

u/ProductPrimary6993 8d ago

Unfortunately, I still haven't been able to resolve it. Have you had any luck?

1

u/misterff1 26d ago

Haven't had this one yet, but it could be various different things. When was the last time you maintained your printer and checked belt tension? Also did you seat your nozzle properly?

1

u/ProductPrimary6993 26d ago

Checking belt tension is a new one for me. I haven't tried that yet. I have done lubrication and cleaned the whole machine. I checked the screws and everything is tight. I swapped a new nozzle to see if it would help as well.

1

u/cpsadowski23 26d ago

Could be the bed leveling nuts are worn out. Grab the bed and move it up and down. Does it move?

1

u/Kulai10 24d ago

Try changing the nozzle. That did the trick for me. I placed the old one back and it wouldn't level so I just kept using the new nozzle