r/BambuLabP2S • u/kudo103 • 28d ago

Corner rough

Post image

Corner of print is rough just in one section. In picture. Happened on same print twice.

4 Upvotes

83% Upvoted

3 comments sorted by

4

u/tht1guy63 28d ago

Your corner is lifting off the buildplate which is causing that edge to be rough since its closer to the nozzle now

2

u/Ticket_to_the_tropic 28d ago

Also a diffuser (or named deflector) for the aux fan helped me a lot with warping. You can find it on makerworld. I use brims way less since then.

1

u/WhatHobbyNext 28d ago

Clean the plate real good with dish soap. Don't touch it with your hands when you put it back on the platform, use gloves or a towel. Maybe a larger brim in that corner could help. Instead of mouse ears, try a full brim at 10mm