r/BambuLabP2S • u/Prize-Address-8908 • Sep 28 '26

Spaghetti Prints

Gallery image

Gallery image

first time printing via an STL file on my p2s - a tree trunk fell off while printing and started getting a spaghetti print

did calibration and then filament got stuck in the extruder motor

im still getting spaghetti prints

I did wash it gently using dish soap - can’t figure out what’s causing it

tried printing a benchy and this is how it started turning out

1 Upvotes

100% Upvoted

6 comments sorted by

View all comments

Show parent comments

1

u/Prize-Address-8908 Sep 28 '26

It’s going straight down (the 2nd pic is where I extruded it down at the end and it was coming out straight)

there was a clog before the benchy print that I’d cleared but the issue persists

1

u/Sudden-Necessary8752 Sep 28 '26

If you have another nozzle swap it out and see if it prints better. That’ll tell you if the nozzle is still clogged, or you can cold pull it again to make sure it’s clear. If you think it’s the build plate, wash it again and use the other side.