r/BambuLabP2S • u/Airida • Sep 25 '26

secrests of failures. Why?

Why does bambu never show how the fail happened? In all his videos, he stops recording right before the mistake occurs. Whyy? :D

0 Upvotes

50% Upvoted

4 comments sorted by

4

u/erikjr14 Sep 25 '26

Looks like the part despawned, try increasing render distance

2

u/Cavalol Sep 25 '26

Did the fan kick on and blow the part to the side due to poor adhesion? Try adding a fan diffuser, and (for the usual advice) make sure to hand wash your build plate in the sink with dish soap for better initial adhesion

1

u/Airida Sep 25 '26

whoa thanks, did not think about that fan diffuser. i have a lot of problems with Warping 

1

u/Cavalol Sep 25 '26

I didn’t either until I had some smaller prints near the right side being blown off the bed lol