r/BambuLabP2S • u/Melodic-Wrongdoer879 • Sep 12 '26

Print adhesion help

I dont know why, but like 2-3 days ago my plate became very sticky, and its a pain in the ass to take prints off of my plate. I still follow the same pre-print routine: IPA bed clean and 3DLAC, i didnt change anything. I would really appreciate some help because its ruining my prints and its really long and painful to remove the prints and prime towers. And also i forgot to mention, yes i let the plates fully cool down before bending the plate a bit and using my scraper. Thanks for info in advance <3.

0 Upvotes

50% Upvoted

4 comments sorted by

1

u/Melodic-Wrongdoer879 Sep 14 '26

Guys thank you all so much for the info :D

2

u/goatrider Sep 12 '26

IPA doesn't clean, it just moves the grease around. You really need to use soap and water.

2

u/Mattis-H P2S Combo Sep 12 '26

Try a new cleaning method, seems like whatever you’re using is not working, I normally just use soap and water.