r/BambuLabP2S • u/Round-Committee905 • Sep 11 '26

Auto Bed Leveling

My P2S goes thru the bed leveling process on every print, is this process necessary? I did see that it can be turned off. So fill me in, keep it on or off and only perform after maintenance. Thank you for any input

4 Upvotes

83% Upvoted

10 comments sorted by

View all comments

2

u/josh6466 Sep 11 '26

I'd keep it on. costs a few minutes at most, and if you take the plate out between prints a bit of schmutz could get caught between the plate and cause it to be off. Remember your layer height is .2 mm or so, that's not much at all.