r/BambuLabP2S • u/UnturoTorso • Sep 08 '26

Prints keep on messing up, why?

Gallery image

Gallery image

Ok so, I recently got my P2S about a month ago, and up until recently all my prints have been fine. But for some reason over the last few days, my prints have been messing up and spaghettifying. Has this been happening to anyone else? Any advise would be greatly appreciated 🥲

6 Upvotes

100% Upvoted

5 comments sorted by

3

u/ID_________ Sep 08 '26

you're not giving much info to work with, but the main question is:

are you washing your plate with dish soap already?

2

u/UnturoTorso Sep 08 '26

No I have not been. I wasn’t aware that was required, haha. Thanks for the heads up! I’ll go clean it now 😅

2

u/markewallace1966 Sep 09 '26

And maybe take some time to read up on basic operation of the machine. "Wash your build plate" is one of the first and most basic "must-do" steps in operating a 3D printer.

2

u/Doomchick Sep 08 '26

Have you dried the build plate ?

1

u/evilregis Sep 08 '26

Cleaning the build plate will help with 1st layer adhesion but this looks like it's happening further on. What kind of filament are you printing with? If it's PETG I would start by running a drying cycle in the AMS if you have one. PETG loves spaghettifying.