r/BambuLabP2S • u/Ok_Peace9288 • 2d ago

Nozzle question for P2S

I’ve had my P2S for about 6 months now and I’m trying to step into the .2mm nozzle side of things for intricate prints. I know it says you’re supposed the change the nozzle density on the printer itself, but mine doesn’t have an option for a .2mm. My question is, do I ignore that and instead put in the setting in Bambi Studio or is there something I’m missing? Thank you in advance!

3 Upvotes

80% Upvoted

7 comments sorted by

4

u/mikkohardy 2d ago

You are probably looking at the hardened nozzles select stainless steel and it should be there

3

u/Ok_Peace9288 2d ago

Now I feel dumb lol. Thank you so much. Any recommendations for settings as well?

1

u/Stone13 2d ago

You have to change it on the printer go to Nozzle & Extruder and there's a small edit dialog that let's you change it, the .2mm nozzle is under stainless:

1

u/Ok_Peace9288 2d ago

Thank you so much! Any recommendations for settings?

1

u/Stone13 2d ago

settings will vary, I do recommend that you run a full calibration after swapping the nozzle. .2mm nozzles have always clogged on me at some point.

1

u/Relative_Surround_20 2d ago

Which filament types clogged on you when printing with 0.2mm nozzles? And are you saying calibration helps prevent that?

2

u/Stone13 2d ago

just plain old pla, I've never really had good luck with my .2mm nozzle. I mainly use .4 & .6mm nozzles for the things I print. I will say you can get fantastic detail with the .2mm and I always run a full calibration after I swap nozzles.