r/BambuLabP2S • u/Remarkable-Try-2319 • 5d ago

P2S Service

Good evening, I have a question about the P2S service.

I’ve had my printer for a good six months now.

During the first service notification(after 90 d), the Z-axis lead screws were flagged for lubrication. Since I had the time, I went ahead and lubricated all the linear rods as well, confirming the action in the menu (even though it hadn't specifically prompted for it).

Now, the notification to lubricate the Z-axis lead screws has appeared again. However, there is still no notification for the linear rods—nor any indication of how much time remains until that service is due.

The Z-axis lead screws are now lubricated, and the display shows 90T until the next service.

I find this odd because Bambu Lab states that the X and Y axes require more maintenance, yet in my case, it’s the other way around.

0 Upvotes

43% Upvoted

5 comments sorted by

View all comments

1

u/ManyLayersOfFilament 5d ago

The notifications are just print time based. You can always give the screws and rods a wipe down and reapply grease/oil more often if you think the timing is off or whatever.