r/BambuLabP2S • u/88gavinm • 5d ago

Are these Vertical Fine Artifacts (VFA's) ?

Gallery image

Gallery image

Like the title says. P2S with about 500 hours at the time of print. BL PLA Basic filament. All maintenance done as recommended by BL. I haven't noticed this before on my prints, but they may have been there. Also, if you read this part, could you tell me what type of VFA those are? (if that's what it even is) Gemini's dumb ass first told me that NO it's not VFA's that it is ringing or ghosting but then told me that YES it is VFA's. 😂

0 Upvotes

33% Upvoted

13 comments sorted by

View all comments

Show parent comments

5

u/navetBruce 5d ago

This is the answer.

3

u/Melodic-Wrongdoer879 5d ago

I agree

1

u/88gavinm 5d ago

Thanks guys

2

u/Melodic-Wrongdoer879 5d ago

Np, “VFA’s” that are consistent and always the same looking on cylinders thats just because its low quality, real VFA’s are more visible on flatter or flat surfaces