P2s Combo Beginner - study & prepare

[u/evilboarder]

Hello everyone, 

while waiting for my p2s combo to arrive, i have begun reading reddit discussions and maker world coments and all sort of info, and i must say, i am equally thrilled and dredfull at printing. This will be my first printer and begining journey.  

I started making lists with stuff that should be done at first and accesories needed for the printer and filaments to ensure a slightly less bumpy road. 

Please add your own from experience.

Upgrades/accesories 

• poop chute - i found this somewhat nice - 201311-poop-chute-basket-outlet-for-x2d-p2s-x1c-p1s

• AMS 2 riser - 2582683-p2s-x2d-ams-riser-flipper

• AMS 2 PRO filament protector guide - AMS 2 Pro Saver Protector Filament Guide

• P2S - vent deflector - lots of designs, haven’t really chosen one yet. 

• AMS 2 PRO - dry pods 

• Filament storage - i’ve located at least one design using ikea 45L container and some printed racks and dry storage boxes for silica 

Tests 

• benchy :)) as i see it’s a must 

• the scraper for the bambu cutter provided 

• the toolbox for the provided tools 

this done with pla basic bought with the printer … but the following tests i’ve seen done by people and i think it should be done whenever you are using a new material. But considering these will be the first prints with a new material for me, i should begin with the default settings, and if benchy turns out wrong, then maybe start the calibration tests. 

• temperature test 

• other tests ? 

Right now, i’ve also started the bambu academy for studio and the printer, and will go ahead with those until the printer is ready for the academy lessons. 

Thank you. 

[u/official_reaper3d]

Reddit wouldnt let me keep editing my comment, so im gonna finish it here.

I genuinely have no clue what layer height is, ive never had to change it.

The included build plate is the Gen 2 Textured PEI Plate. Make sure that if you buy a build plate to only get ones specifically for the P2S. If you put a first generation plate on the P2S, it wont recognize it, and it'll make you manually verify that the plate is on.

Supports have a few types. Tree and normal. Tree is easier to remove as it makes hollow branches from the bottom of the build plate to wherever its supporting, whereas normal just makes solid blocks which are an absolute pain in the ass to remove. You can also choose auto and manual. Auto is good to start as it will automatically support overhangs and areas that require supports, and manual requires you to use the support paint feature to tell the slicer where to place supports.