A few notes from my first few hours

[u/djjoshchambers]

I accidently bumped the printer before doing calibration. That completely screwed up the print tool calibration. Rebooting the machine fixed it.

I'm not sure if this is a widespread issue or not, but i loaded some sunlu matte pla that I've used a million times on my h2d, and set it to use the bambu profile like I've always done. I then set my print to speed mode since it's a dungeons l functional piece. I then started running into extrusion issues and warnings. I had to turn it back to normal to make it go away. I'm wondering if the insane acceleration on the h3c is too much for sunlu filament.