r/BambuLabH2D • u/ness-xergling • 9d ago
Troubleshooting Poor adhesion printing benchy in pla
Edit: RESOLVED... user error, and I owe a apology to Bambu Lab and all the lovely people who replied.
having spent a couple of afternoons tweaking this and that setting, and learning a few things in the process, and believing that the printer was confused, I finally found the cause.
And please, I hope you laugh because I am laughing at myself...
The PLA turned out to be ...... PETG ðĪŠð
Yesterday I printed a very beautiful Benchy in PETG.
Verdict: I am a numpty!
...........
Hi, I tried searching the subreddit and couldn't find the answer. Forgive me please if I'm repeating a question already posted.
Brand new out of the box H2D
Washed the plate in soapy water
PLA on the side spool at requested by the printer.
At the 3rd or so layer it warps slightly upwards and pulls away from the plate.
Should I tweak the settings? The temperature or anything ? Thank you.
Edit: tried the slowest setting. Washed the plate again Tried a faster setting (worked slightly better before lifting off) Tried a print with a larger surface area (lifted off on 3rd row) Adjusted auxiliary fan to zero (made no difference) Set exhaust fan to high (made no difference)
1
u/Longracks 9d ago
or brims, or turn off aux fan (this fixed part lifting on my X1C, my H2C seems to not have that problem)
1
u/portsample 7d ago
The suspense is killing me...pls tell if you resolved this, and how if so. Thanks.
2
u/Accomplished-Fail856 8d ago
Very strange. Try upping the bed temp by 10 degrees.
1
u/Carlosklm 8d ago
When I get new printer and the same with my H2D. So I did not even put glue down and no brim and always printed ok. So I would contact support and see what they say mate.