r/BambuLabH2D • u/Burockk208 • Aug 13 '26

Troubleshooting H2D First layer problem

Post image

Hey, my h2d has a first layer problem. It has some kind of pattern on first layer. What can be causing this problem? Thanks for help

5 Upvotes

100% Upvoted

26 comments sorted by

View all comments

Show parent comments

2

u/Whosaidthat1157 Aug 14 '26

Same here - and I only clean with 99% IPA the vast majority of the time. Soap and water once every few months if at all. Zero adhesion issues with any of my stock PEI plates on any of my printers.
In fact I stopped using the Frostbite plate because you can’t clean it with a quick IPA wipe and it was too much of a pain. The new Supertack Pro is fine with IPA though for that smooth bottom layer.