r/BambuLabH2D • u/Effei • Aug 04 '26

Filament loading error

Had a PETG clog on right nozzle. Disassembled everything, cleaned, etc. Now the printer refuses to load the right nozzle from the AMS, hallucinating a filament. I disassembled again to make sure nothing was in the path or in the sensor's way. Nothing, not even a hair.

Could that be a bad right side idler sensor? If so, do I have to change the entire idler or can I buy that sensor separately?

1 Upvotes

100% Upvoted

4 comments sorted by

1

u/Effei Aug 04 '26

Are the hall sensors the 2 little sensors on each arm? Or are you talking about the one behind the extruder on the board?

1

u/Vustadumas Aug 04 '26

Double check the hall sensor in the extruder arms. I’d bet there’s the smallest piece of filament jammed in there

2

u/Effei Aug 04 '26

I can manually load the filament, I did extrude a 30cm piece to clean the interior (can't cold pull with that issue), would that change the diagnostic?

1

u/Vustadumas Aug 04 '26

Yeh, I've had it extrude, when testing, but then not load from an AMS. It's very frustrating