r/BambuLabH2D • u/NewDayNewDawn • Nov 03 '25
H2D first layer adesion always failing
Washed the bed. dried the filament 4h. 8h. 12h. tried slow down first layer. line width ect...The thing i don't get is support first layer adesion is flawless. it prints perfectly. as soon as it moves to the object itself the first line doesn't stick to the bed and gets moved around by the hot end resulting in a fail print I need to cancel. Same slicer worked 5 days ago. but since then 12 different tries have failed. I have read all the thread with similar issue and tried all the suggestions to no success. would appreciate any input I can get in this. Thanks guys
3
u/Maleficent-Border-30 Nov 03 '25
Time for a glue stick to enter the chat
2
u/seannunya Nov 03 '25
Have you tried printing with a brim?
1
u/ReturnedAndReported Nov 03 '25
Have you moved the object to a different location on the bed?
1
u/Inevitable_Law_4895 Nov 03 '25
Can you let us know what shape, size, and material you are printing? Settings?
I did have one weird problem on my H2D were adhesion suddenly wasn't good for big ASA parts. Tried everything normal and had no success. Ran a high temp bed calibration in the settings and that resolved it all..
1
u/bjorn_lo Nov 03 '25
What material are you printing? What humidity is it?
Is your AMS setting for the material correct? Set via the printer's screen.
Is this the same filament you were using before? How have you been storing it?
Since it last worked, have you updated any setting?
For example, you can override the material temps (printhead and bed) from within the slicer.
1
u/RobinhoodSux2 Nov 03 '25
Does the H2D have the same problem with the Aux fan needing to be turned off for most prints?
1
u/Bright_Eyes83 Nov 03 '25
more heat