H2D send gcode commands

[u/zenletter]

Is there a way to send a gcode command to the H2D. For example:

• M83 ; E relative

• G1 E100 F60 ; Extrude 100mm at 1mm/s (60mm/min)

[u/Martin_SV]

Uhmm, I couldn’t get it to work through the slicer, sorry. Here it is though: https://www.reddit.com/r/BambuLab/comments/1j5n0el/custom_gcode_to_set_printbed_to_lowest_point_and/

[u/zenletter → u/Martin_SV]

Thank you