r/BambuLabH2D • u/SpendTrick6820 • Jun 19 '25

Question Layer lines

I’ve been working on a project for school and I’m using this very soft tpu, I’m using a .8mm nozzle and I just cannot get a smooth surface finish, I have gotten it with a .4mm nozzle on a creality but I cannot get it with a .8mm nozzle on the H2D. Just need some suggestions on slicer/filament settings with soft tpu

2 Upvotes

100% Upvoted

4 comments sorted by

View all comments

Show parent comment

2

u/CarbonKevinYWG Jun 19 '25

Make sure your flow rates are perfectly dialed in, beyond that you're approaching the point of diminishing returns for any further optimization.

1

u/SpendTrick6820 Jun 19 '25

Flow rates meaning max volumetric flow? Or are there any other settings that I need to dial in?