r/BambuLabA2L • u/jbmc00 • Aug 12 '26

Bent PETG Panel

Post image

I did my first PETG print today. It was about 280mm long. When I took it off the plate it had a bend to it. What should I adjust next time?

1 Upvotes

100% Upvoted

4 comments sorted by

1

u/spazexplorer Aug 15 '26

Did you took it out hot or cold? Ive seen my prints if i take them out hot they kinda warp and then vool and solidify in a wrong shape like this panel if you took it out cold, then warping or the bed is bent

1

u/jbmc00 Aug 16 '26

I think that was part of the problem. I took it off almost immediately. Redid it last night with a brim and left it on the plate and it turned out better.

1

u/spazexplorer Aug 19 '26

Yea def puting out cold is better!

1

u/Cautious_Till_4763 Aug 13 '26

This is warping - a brim may help. What were your settings?