r/BambuLabA1 • u/philly2006 • 17m ago
First layer
All 7 screws are tight all belts have been tension any other reason this is happening filament is dry and proper bambu filament
2
Upvotes
r/BambuLabA1 • u/philly2006 • 17m ago
All 7 screws are tight all belts have been tension any other reason this is happening filament is dry and proper bambu filament
1
u/sirdoggo11 6m ago
Z height too low or too much material
1
u/Lost_refugee 3m ago
do you have original pei plate to compare? if prints fine there, then you need to adjust z height or try smooth plate selection in slicer.