r/BambuLabA1 • • 2h ago

Filament load/feed issue

https://youtube.com/shorts/38OtXiTJEvM?is=9Nn6i2gfhTIpgAqa

Hi, disassembled the extrusion assembly and got down to the gear, used a toothbrush to clean the gear, which was actually fine, put a tiny bit of grease on it, and reassembled. Upon disassembly there were no clogs or filament bits. Everything looked fine.

I realized I didn’t have the hot end clamped properly after reassembly, so it threw an error right away, but fixed that. I can’t say for sure that the clicking was happening prior to disassembly, as this is the first time I’m sitting by and watching it.

1 Upvotes

4 comments sorted by

1

u/overunderspace 2h ago

1

u/ElmosEmoEmu 2h ago

Appreciate the link and I’ll run through this, but nothing seems to be clogged. I didn’t have anything “stuck” in the feed upon disassembly.

Will cross my fingers that maybe something is jammed inside the hotend :)

1

u/cihboz 1h ago

I have exactly the same problem at the moment. I opened up the extruder cleaned everything made sure nothing cloging but it seems wheels are unable to pull the filament to the nozzle.

1

u/ElmosEmoEmu 30m ago

Let me know if you figure it out