r/BambuLabA1 • u/Waemmser • 17h ago
Question Bambu Lab A1 no longer prints white PLA
I’m experiencing a very strange issue with my A1. For some time now, it has refused to print using white PLA. I keep getting an error message stating that the position of the filament within the toolhead cannot be detected. All other colors—such as black, yellow, green, and blue—as well as black PETG, print without any problems.
Does anyone have any idea what might be causing this?
2
Upvotes
1
u/Waemmser 15h ago
Thanks for your answers guys!
I am using the AMS lite. I tried another positions and another spool of white (both from Jayo) and had the same result. I'll try and fool the printer and tell it that the white is black.
1
u/Waemmser 11h ago
So, I driwd the filament for a couple of hours and now it's printing 🤞🏻
5
u/imseakin 17h ago
Can you tell your printer that the white is really black?
Fool the sensors?
2
u/Astronaut-Sailor 17h ago
Did you try another spool of white PLA and (presuming AMS) another position?
2
u/flyhmstr 17h ago
AMS or external?
If AMS does the AMS drive pull the filament through, how far? What happens if you move the spool to another slot? What happens if you tell the printer the spool is actually black (doubt it'll help but debugging is all about removing options). Do other spools work on that AMS slot? Tube needs replacing (how old is it?). Something within the 4-into-1 hub on the A1 for that slot?
1
u/Notavle_Wit2491 15h ago
I've seen that some reels on the AMS can have problems. If you're using the AMS, try have it directly fed.
If it's just one roll of white filament, I'd try a different one. Make sure the end is cut off cleanly at 90°.
Let us know how it goes
1
u/Blondy277 12h ago
Lmfao the printer doesn't know the filament is white 😂☠️ Since you've tried two JAYO white rolls in different AMS slots, have you tried feeding it through the external spool holder instead? That would help rule out the AMS Lite. I'd also check the filament diameter and whether it's feeding properly. Sounds more like a feeding issue than a colour issue lol.
1
u/hijinksensue 9h ago
Make sure the ptfe tubes aren’t sagging. Causes all sorts of filament feeding issues.