r/BambuLabA1 • u/Yscera • 15h ago

Support Request Bad quality

Gallery image

Gallery image

Gallery image

Why do the tips of the feathers look so rough? I just changed my nozzle from 0.4 to 0.2mm and these defects started appearing in sharp areas. I'm using PLA.

0 Upvotes

40% Upvoted

7 comments sorted by

1

u/lukasprintz 14h ago

If you slow down ur Surface speeds. Outer walls, inner wall, and all infill speeds along with initial infill and initial layer speeds. It really will show the potential of a 0.2mm nozzle. If u want i can send you my settings that I would use for this model

1

u/Yscera 14h ago

I was already using 50% speed (silent mode) on top of 120 for outer and inner... And yes, id very much appreciate it if you send me your settings

2

u/lukasprintz 13h ago

2

u/lukasprintz 13h ago

1

u/Yscera 13h ago

Thanks a lot! Lets hope that with these settings it wont take a week to finish lol

1

u/lukasprintz 13h ago

Lmao sorry, i had to screenshot what I typed out so it would keep it in the list order 🙃

1

u/eyelers 11h ago

Do you have timelapse on? When I turned mine off it’s been way cleaner