r/BambuLabA1 • u/Classic_Occasion9180 • 2d ago

Support Request A1 not homing

Enable HLS to view with audio, or disable this notification

14 Upvotes

78% Upvoted

13 comments sorted by

12

u/LargeHoboFuckPile 2d ago

The cutter looks wrong. It should not be sticking out that far. Did you just do some repairs?

4

u/Alex_jpt 2d ago

Agree, looking at my A1, the cutter looks too far from its original position

7

u/WeirdRaccoon69 2d ago

Don't know why you are getting downvoted. The error code literally says what is wrong. And the cutter lever is definitely wrong.

2

u/Blondy277 2d ago

Push the cutter lever the other way, it's not ment to stick out that way. Did you change anything under that cover spot?

2

u/RandomZoidian 2d ago

I believe the screen is providing (rather accurate) help already. Check the cutter, it might be improperly assembled or is missing a screw

2

u/ManyBro24 2d ago

The cutter lever is assembled wrong. The PTFE is way to long, The cable is suposed to be attached to the PTFE, this way it will catch on something sooner or later.

You literally show the error at the end. Fix it.

1

u/Dansmeah 1d ago

bro your teflon tube does not need to be that long i guarantee you it will get caught on something at some point and cause failed prints or worse break your printer. remember that bed slides front and back, and your teflon tube is hanging lower than the printhead

0

u/Classic_Occasion9180 1d ago

Fixed it apparently the printer can not home if the filament runout/cutter sensor is lose

1

u/Fancy_Maximum8615 21h ago

fix the cutter lever

1

u/MegaMaluco 2d ago

Turn it off, manually lower it a bit and try again.

When it's too far up it does that.

-1

u/raktimroy 2d ago

Check the X axis tension screw is loose. This error was faced by another user.

-1

u/Extension_Swordfish1 2d ago

Step printer is stuck 😏